Quick Gt-four question, all you gt-four /replica guys Options

[RbrtNdrws]

Hi guys,

I've got the gt-four bumper on my car with the stock hood until I can locate the gt-four hood. Anyway, I cut the stock crash bar and used it and right now I have the bumper bolted on at the fenders on either side and at the bottom with all of the underbody plastic.

Is there a special piece that I need to go on the top of the bumper? Right now I'm using the stock black plastic piece with the rubber seal and I have it screwed on near the headlights. Theres a gap in the middle, do I need to have something under the gap to keep the bumper held up or what?

If that's confusing I'll post a picture if it helps. Basically I'm asking how does the middle section attach if there is a 1/2 inch gap in between the bumper and the rest of the car.

Thanks,
Rob

[97lestyousay]

I made a couple alluminum spacers with a tapped hole for bumper cover
hold down bolts, and a slot that attaches to the radiator support(edit: bumper support bracket)
, so it has a little adjustment. It works ok but I am in the process of designing and making a full
length bar that works like this but ads support through the whole area with the gap.


Edit: I forgot you are trying to use the stock bumper.nvm

This post has been edited by 97lestyousay: Jun 17, 2007 - 4:07 PM