HELP! ST202 fog light wiring, car is taken apart! Options

[phokur]

I am trying to install my ST202 fog lights and I am stumped. In the car's fuse box inside the car, there is a fuse called "FOGS". Mine even has a 20amp fuse in it already. I can't seem to find where it leads outside the car. Where is the switch/output for the fogs?

[phokur]

Thanks for the replies! That's how I'm thinking to do it netrata. I have the relay next to the fuse box and a switch on the dash. I just need to figure out how to route the wire from the dash to the relay. Where did you put the wire to go from the cabin to the engine bay? I'm thinking of drilling a hole about 4" under the steering shaft and just sticking it through... that is, unless there is a predrilled wire hole that has room for one more that I've missed.

[netrata]

I used the same hole that was already there from the celi's previous owner when they got the car alarm installed. I'm pretty sure it's a hole drilled about 2 or 3 inches from the steering shaft, but I can try and verify and possibly post some pix up tomorrow morning. I just followed the diagram that comes with the fog light wiring kit. Unscrewed/pry the whole bottom panel below the steering wheel to route the wiring from the firewall to the fuse block, then to the fog lamp switch. I secured all of the wiring with with zip ties and made sure it was wasn't noticeable. Then I reloomed all of the wiring from the firewall to the battery and all the way to the fog lamp. If you want to know what switched I used, I actually bought a factory toyota foglamp switch off ebay for like $13 and located it on the right side of the steering wheel where there's a rectangle-shaped piece on the lower dash panel. Just pry that off and the fog lamp switch fits right in perfectly.