Requesting 3sgte Help, pix inside, Help me figure out where these plugs go Options

[CelicaSTX02]

Hey guys,
I just got my wiring back from Dr. Tweak. I am trying to swap a ST185 3sgte into my OBD2 1997 Celica GT. There are several plugs that I don't where they go. The last mechanic I took my car to put the engine in and never got it running. Messed everything up, so now I have to fix it. Please take a look at these pictures and tell me if you see something wrong and also let me know what these plugs are and where they should go. In the meantime, I will do research and look through old posts to figure it out myself, but if you happen to just know, please post and save me some time. Thank you very much in advance for your help!!

-Anh-Tuan
















This post has been edited by CelicaSTX02: Aug 11, 2007 - 4:49 PM

[95celgt]

how do you ground the noise suppressor? i dont see a way to do it its not like you can put a bolt through it?

btw, that relay goes in your main fuse box...

[toyotacrazy]

how do you ground the noise suppressor? i dont see a way to do it its not like you can put a bolt through it?

btw, that relay goes in your main fuse box...

there should be a bracket coming off the noise supressor. It may not be or need a ground.

[phattyduck]

how do you ground the noise suppressor? i dont see a way to do it its not like you can put a bolt through it?

btw, that relay goes in your main fuse box...

there should be a bracket coming off the noise supressor. It may not be or need a ground.

If it has two wires going to it, it does not need to be grounded (one of the wires is already ground). It should be in the harness near where the ignition coil is located. On my ST205 harness/motor, there is a spot to clip it on the ignitor/coil bracket (that ignitor/coil bracket DOES need to be grounded).

-Charlie