HIGH beams to LOW beams, convert? Options

[NickJames]

I don't know exactly where this should go...its exterior...yet its electrical....anywayz, anybody got an idea on how I can get my 2 high beams to just be low beams along with my out ones....is it just a matter of re aiming or what...any help would be greatly appreciated...........thanx fellas

[Aleksander]

I was going to create a new thread but this one was very similar to the problem I have. I don't mean to capture your thread or anything, NickJames.

Is there any way to adjust the height of the beam of the 'high' lights? Both of my high beams point way too low! They hit the ground almost at the same point as my 'lows' do, wich is adjusted at the farthest ahead "0" setting. Here in Norway it's completely pitch black almost half the day at these times of year, and driving without proper lighting is dangerous (even more so at high speeds with wet asphalt..) I've just had the car for a couple of months, so I haven't noticed this before now. I tried screwing the long screws that stands out in the back of the lights but I didn't notice any difference.. Any hints would be a life saver

This post has been edited by Aleksander: Sep 16, 2007 - 6:01 PM

[Harold_Fastwaker]

I was going to create a new thread but this one was very similar to the problem I have. I don't mean to capture your thread or anything, NickJames.

Is there any way to adjust the height of the beam of the 'high' lights? Both of my high beams point way too low! They hit the ground almost at the same point as my 'lows' do, wich is adjusted at the farthest ahead "0" setting. Here in Norway it's completely pitch black almost half the day at these times of year, and driving without proper lighting is dangerous (even more so at high speeds with wet asphalt..) I've just had the car for a couple of months, so I haven't noticed this before now. I tried screwing the long screws that stands out in the back of the lights but I didn't notice any difference.. Any hints would be a life saver

Each housing has 2 adjustment bolts. Up/Down and Left/Right. Just turn your lights on and your high beams. Point them at the side of your house or a building. And start adjusting them with box wrenches.