 Can't get my car into gear |
 Sep 26, 2007 - 5:42 AM
|
 
|
|
Enthusiast  Joined Aug 19, '07 From Farmington, MI Currently Offline Reputation: 7 (100%)  |
Hi, at first i believe this problem was hydralic, but its not, i can see the slave cylinder pin pushes out the clutch fork, but i can't get it into gear, i can go thorugh gears while the car is off, but not on, and when i start the car in first, if i hold in the clutch it doesn't move, but once u let up a little, it will start to engage very early, also there is a squeaky noise always going, unless i push in the clutch all the way
|
 |
Replies
|
Sep 26, 2007 - 10:00 AM
|
|
 Enthusiast Joined Feb 24, '07 From Oahu, Hawaii Currently Offline Reputation: 23 (100%) |
oil level???? bleeding????? clutch fork???? throw out bearing thing????? or just your clutch needs to be changed??????? or adjust the clutch pedal play......................
-------------------- I don't normally drive fast, but when I do its on a curvy section of this island
 |
Posts in this topic
supra12big Can't get my car into gear Sep 26, 2007 - 5:42 AM
95celgt What clutch are you using? if its an aftermarket w... Sep 26, 2007 - 8:55 AM Insanity-74 How many miles has the clutch done? I suspect that... Sep 26, 2007 - 9:04 AM eggman40 sounds like your clutch may be gone. How long have... Sep 26, 2007 - 9:57 AM x_itchy_b_x I'd bleed it again. rule that out first then g... Sep 26, 2007 - 10:05 AM supra12big i have bleed it about 15times, and the slave pin i... Sep 26, 2007 - 1:44 PM rjbibeau bad master cylinder change it out. how long did th... Sep 26, 2007 - 2:22 PM x_itchy_b_x maybe a spring came out of the clutch disc and is ... Sep 26, 2007 - 2:35 PM twitchh17 shoes Sep 26, 2007 - 6:53 PM supra12big i dunno i replaced the master cylinder, and i have... Sep 26, 2007 - 7:50 PM
rjbibeau so did you just replace the clutch or have you bee... Sep 27, 2007 - 10:02 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: August 3rd, 2025 - 1:37 PM |