 Can't get my car into gear |
 Sep 26, 2007 - 5:42 AM
|
 
|
|
Enthusiast  Joined Aug 19, '07 From Farmington, MI Currently Offline Reputation: 7 (100%)  |
Hi, at first i believe this problem was hydralic, but its not, i can see the slave cylinder pin pushes out the clutch fork, but i can't get it into gear, i can go thorugh gears while the car is off, but not on, and when i start the car in first, if i hold in the clutch it doesn't move, but once u let up a little, it will start to engage very early, also there is a squeaky noise always going, unless i push in the clutch all the way
|
 |
Replies
|
Sep 26, 2007 - 2:22 PM
|
|
 Enthusiast Joined Sep 6, '04 From oakdale Mn Currently Offline Reputation: 0 (0%) |
bad master cylinder change it out. how long did the clutch line stay open for.....the seals most likely dried out and when you went to push the clutch it it ripped the oring. happened to my g/f's 3s mr2. we bleed the thing for like an hour and still it wasn't holding pressure so we changed the master out and boom we got clutch.
This post has been edited by rjbibeau: Sep 26, 2007 - 2:31 PM --------------------  |
Posts in this topic
supra12big Can't get my car into gear Sep 26, 2007 - 5:42 AM
95celgt What clutch are you using? if its an aftermarket w... Sep 26, 2007 - 8:55 AM Insanity-74 How many miles has the clutch done? I suspect that... Sep 26, 2007 - 9:04 AM eggman40 sounds like your clutch may be gone. How long have... Sep 26, 2007 - 9:57 AM 808celica oil level???? bleeding????? clutch fork???? throw ... Sep 26, 2007 - 10:00 AM x_itchy_b_x I'd bleed it again. rule that out first then g... Sep 26, 2007 - 10:05 AM supra12big i have bleed it about 15times, and the slave pin i... Sep 26, 2007 - 1:44 PM x_itchy_b_x maybe a spring came out of the clutch disc and is ... Sep 26, 2007 - 2:35 PM twitchh17 shoes Sep 26, 2007 - 6:53 PM supra12big i dunno i replaced the master cylinder, and i have... Sep 26, 2007 - 7:50 PM
rjbibeau so did you just replace the clutch or have you bee... Sep 27, 2007 - 10:02 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: December 9th, 2025 - 3:00 PM |