supershannon77's new 5SFTE powered celica, NEW DYNO RESULTS PG5 285+WHP! PG6 vid added! Options

[presure2]

Hey all,
as some of you may know, shannon and jim (supershannon77) have a 3sgte swapped 6gc, that they bought from RJB on the forum.
They started off with a 91 auto GT, that they had a local shop install a "ebay special" turbo kit on. the shop installed the kit, and promptly blew the motor @ 5.5 psi.
shannon then had the shop source and install a 99 5s, and made ~147whp if I remember correctly, with the auto tranny, @ 5.5psi
They then blew said auto tranny. lol
So, IIRC, they sold the 5th gen to a friend, and bought RJBs car.
They have had a few problems with it, including a bad tranny, which Defgeph and I went down and replaced for them.
While i was down there, jims brother joe bought the old 5th gen back, with the blown tranny, and fresh 99 motor in it.
We disscussed diffrent options for it, including a manual tranny swap, but with the car having pre 93 electronics, and no knock sensor system, I convinced them the best thing to do would be to find a nice 6th gen chassis to swap the engine package into.
At that time, we also disscussed power goals, and to me, it seemed like Jim and Shannon were just looking for a streetable, everyday drivable car, with ~225 or so hp, to make the trip a bit more enjoyable .
Where Joe, on the other had, is really looking to build a BEAST down the road, 350+whp ect.
Fast forward a few weeks, and browsing the FS section here on the board, I see a nice 95 with a blown motor. http://www.6gc.net/forums/index.php?showtopic=49717&hl=
Bing, Bang, Boom, Jim and Joe are on it, and go put a deposit on the car.
We set everything up, and a few weeks later, Jim, Shannon, and Joe, load the 5th gen INTO the back of a uhaul truck, put the 6th gen on a car hauler attached to the back of said uhaul, and drove them up here.
here are some pics and discriptions of whats gone on since.

They arrive with the cars:


We get the 6th gen off the car carrier:


HOLY CRAP, they really DID stick the 5th gen in the back of the Uhaul!!!!!


this was NOT as easy as it looks:


mmmm yellow nology wires!! LMAO


With that done, the following morning we got right to work, and got the cars up and draining, and prepped to get the bad motor out:




Then we pulled the motor and tranny out of the 6th gen:

[cHinaman727]

gawd i love it.... so how much did they spend doing all this?

[presure2]

gawd i love it.... so how much did they spend doing all this?

well, since they bought me the turbo kit basicly prefabricated ( i just had to install it all to fit the 6gc, and make it reliable) its hard to give a price on everything.
since the car has been up here theyve spent ~2500 with paint and all, plus 500$ for the install of all the parts & motor.
i gave jim and shannon a great price on labor, cause they are good friends of mine.
after what they have been thru with the 5th gen they originally had and the shop that totally screwed them on the install back then, and the swapped car, i built this with the idea that they will be able to just DRIVE it, (other than your basic mantinence of course) with no worries, and am confident they will be able to do just that, for as long as the ebay turbo holds out, or till they decide to replace it, whatever comes first.