 5SFE Rebuild, Engine Bore .02 |
 Oct 19, 2007 - 4:21 PM
|
 
|
 Enthusiast  Joined Sep 21, '07 From FL Currently Offline Reputation: 0 (0%)  |
Currently rebuilding my 5SFE and I am taking my block to the local machine shop. $30 per cylinder. Would there be any significant increase if I went .02 (.5mm) over? Also what else would I need besides new pistons and rings?
This post has been edited by cv7713: Oct 19, 2007 - 4:54 PM |
 |
Replies
|
Oct 19, 2007 - 6:17 PM
|
|
|
Enthusiast Joined Sep 21, '07 From FL Currently Offline Reputation: 0 (0%) |
thanks. plans include the following:
possible bore .02 over (not sure, need some more suggestions) new pistons, rings, bearings, seals (whole bottom end basically) reman head oil pump, water pump, timing belt, thermostat lighter flywheel and new clutch qeustion: if I want to boost the 5s in the future, how would the .02 bore effect things??? any ideas? |
Posts in this topic
cv7713 5SFE Rebuild Oct 19, 2007 - 4:21 PM
cv7713 apparantly this is more complicated than that (or ... Oct 19, 2007 - 4:53 PM Kwanza26 Bare minimum... new pistons and rings (should incl... Oct 19, 2007 - 6:00 PM
blooddriveg6 I was thinking for a while about doing the 3sgte s... Oct 20, 2007 - 8:25 AM Kwanza26 QUOTE(cv7713 @ Oct 19, 2007 - 11:17 ... Oct 19, 2007 - 6:25 PM cv7713 should I shave a little bit off of the head? Oct 19, 2007 - 6:38 PM Kwanza26 QUOTE(cv7713 @ Oct 19, 2007 - 11:38 ... Oct 19, 2007 - 9:43 PM cv7713 that's completely personal preference. what d... Oct 20, 2007 - 12:37 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 22nd, 2025 - 8:10 AM |