 5SFE Rebuild, Engine Bore .02 |
 Oct 19, 2007 - 4:21 PM
|
 
|
 Enthusiast  Joined Sep 21, '07 From FL Currently Offline Reputation: 0 (0%)  |
Currently rebuilding my 5SFE and I am taking my block to the local machine shop. $30 per cylinder. Would there be any significant increase if I went .02 (.5mm) over? Also what else would I need besides new pistons and rings?
This post has been edited by cv7713: Oct 19, 2007 - 4:54 PM |
 |
Replies
|
Oct 19, 2007 - 6:38 PM
|
|
|
Enthusiast Joined Sep 21, '07 From FL Currently Offline Reputation: 0 (0%) |
should I shave a little bit off of the head?
|
|
Oct 19, 2007 - 9:43 PM
|
|
 Enthusiast Joined Dec 27, '03 From Nor Cal Currently Offline Reputation: 0 (0%) |
QUOTE(cv7713 @ Oct 19, 2007 - 11:38 PM) [snapback]606667[/snapback] should I shave a little bit off of the head? You can... again, considered maintenance... but if you plan to turbo... probably best not to because machining to head can somewhat increase compression. -------------------- "It's ok to be naked girl... I'm an artist!"
1995 AT200 Celica ST: stocked out daily driver... 1984 AE86 Corolla GT-SR5: silvertop 20V 4AGE project car jacked up with goodies... 1991 SW2x MR2 n/a: bare bones hardtop model soon to be... |
Posts in this topic
cv7713 5SFE Rebuild Oct 19, 2007 - 4:21 PM
cv7713 apparantly this is more complicated than that (or ... Oct 19, 2007 - 4:53 PM Kwanza26 Bare minimum... new pistons and rings (should incl... Oct 19, 2007 - 6:00 PM
blooddriveg6 I was thinking for a while about doing the 3sgte s... Oct 20, 2007 - 8:25 AM cv7713 thanks. plans include the following:
possible bo... Oct 19, 2007 - 6:17 PM Kwanza26 QUOTE(cv7713 @ Oct 19, 2007 - 11:17 ... Oct 19, 2007 - 6:25 PM cv7713 that's completely personal preference. what d... Oct 20, 2007 - 12:37 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 21st, 2025 - 2:25 PM |