Help Update: Speedo Still Not Working Options

[Chanh55]

We just completed swapping her all the hoses and stuff are connected.... I think..

This is from a 6gc with a completed swap...

I did a auto to manual swap, does it matter if I connect the park neutral thing in order to start the car? If so... where is that wire at?

When I turn the key, everything sounds normal... but the starter doesn't turn over...

Please help... I'm thinking it's something with the wiring. I'm stumped.

This post has been edited by Chanh55: Mar 22, 2006 - 5:23 PM

[95celgt]

so i got bored today and decided to poke at the wiring in the car to see if the speedo will work using this diagram:




here it shows the 3 wires that go to the speedo from the speed sensor, theres wire 1 which is red/blue stripe, wire 2 is blue/black stripe and 3 is solid blue. At the sensor plug wires 1 and 2 were intact, and 3 was cut at the scene, for sum reason its blue (the way its supposed to be but after an inch into the harness its gray so i assume this is why it was cut, and a wire was spliced and routed into junction plug 3 behind the HVAC but infront of the ECU with a blue/white stripe wire, and the non plug side was left there. There was another side that was also cut in that area and T'd in somehow....

well, I first started to "fix" the mess at the 3 junctions by the ecu, so i got rid of the splice point and put blue/white and blue/white back together, then solid blue with its solid blue...so that the harness matched itself again, and after looking at the pic, it shows that wire 3 merges with a gray (i assume ground) at the gauge cluster circuit board, an there is a screw at that circuit path with a b next to it. So i got wire 3 directly from the speed sensor on the tranny and looped it on the screw....well long story putting everything back together, but in the end the speedo still didnt work......What did happen though is the i no longer get a CEL for speedsensor (code 52 i think), so no more CEL's but speedo still doesn't roll:(