 boost gauge tap point, read the forums...ended up tapping in here. |
 Nov 16, 2007 - 8:36 PM
|
 
|
 Enthusiast  Joined Aug 7, '05 From Columbus OH Currently Offline Reputation: 3 (100%)  |
I want to make sure this is an ok place to tap into for my boost gauge. This is a jdm 3sgte st205 and I'm currently tapped into the line that goes into my BOV. I tried tapping into the line suggested on the st205 repair / maintance sticky, but had limited results. I'm currently reading -15 at idle. It increases through the gears, but really jumps in 3rd to 18psi when I get on it. Just want to make sure this is an ok place and these readings are ok. Pardon the tape...it's temperary for now. Thanks for you help.
--------------------  |
 |
Replies
|
Nov 17, 2007 - 8:11 PM
|
|
 Enthusiast Joined May 12, '06 From Wilmington, NC Currently Offline Reputation: 45 (100%) |
I dunno about the 3sgte, but the 5sfe has little nipples off the intake manifold that are capped off. remove one of the caps and voila! I'm not really sure, but placing it there may interfere with the BOV operation.
--------------------  94 GT - Sold -------- 69 Pontiac Lemans - Sold 88 Alltrac - Sold ---- 04 WRX - Sold 00 GT-S - Sold ------ 91 Miata - project/drift car 95 GT - Sold -------- 96 GT - New Daily Drive |
Posts in this topic
CELL_PROTOTYPE_X boost gauge tap point Nov 16, 2007 - 8:36 PM
CaliJeff as long as u use one of the t's, and its secur... Nov 16, 2007 - 9:40 PM beno look here
http://www.6gc.net/forums/index.php?sho... Nov 24, 2007 - 12:39 AM toyotacrazy Is that a plastic T? If so it may melt on hot sum... Nov 29, 2007 - 6:13 PM
CELL_PROTOTYPE_X Oh thanks for the advice...it is a plastic one. Mi... Nov 29, 2007 - 6:32 PM OOBE You should. Nov 29, 2007 - 8:30 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: September 16th, 2025 - 6:34 PM |