6G Celicas Forums

Welcome Guest ( Log In | Register )

> What are the Requirments for changing my struts, New KYB's and S-Techs in the mail
post Dec 6, 2007 - 10:32 PM
+Quote Post
k-weaver



Enthusiast
**
Joined Jun 5, '07
From Santa Maria
Currently Offline

Reputation: 1 (100%)




Ok, so I have been wanting to change my suspension ever since I got my car and the time is finally coming. I just purchased and received some KYB GR-2's and my teins are in the mail. I just had a couple of questions on what is needed for the install.

1.) Can I use the orignal stock mounts that are at the top of the strut? (I'm refering to the piece that holds the spring on from the top end)

2.) I noticed that someone else recently did an install of the same set up and he used what appeared to be a rubber piece on the strut. Right where the spring would sit on the strut (bottom of strut), are these necessary?

3.) How hard are these bolts going to be to get off?

4.) Is there a certain way you need to place the spring onto the strut? Or can you just slap it on there?


--------------------
IPB Image
 
Start new topic
Replies
post Dec 11, 2007 - 2:31 PM
+Quote Post
94celigts



Enthusiast
**
Joined Jun 13, '07
From Whitby, ON, CAN
Currently Offline

Reputation: 6 (100%)




grease(alot of grease) all bearings in top mount, and grease the top of the springs and the rubber it will sit into on the bottom of the top mount it will make for no sounds, i didnt the first time took it apart the next day to redo.


This post has been edited by 94celigts: Dec 11, 2007 - 2:31 PM

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: July 22nd, 2025 - 1:37 PM