Distributor cap, plug wires, and connection plug to the ignitor, Looking for recommendations Options

[CelicaSTX02]

Hey guys,
I am still working on this 2nd gen ST-185 3sgte swap, just need to hook up everything and replace a few parts. Anyways, I've seen a couple of distributor caps and spark plug wire options out there and I am trying to get some recommendations as to what I should use to replace mine's. I need to replace my distributor cap, spark plug wires, and there's this short connector plug wire that goes from the distributor cap to the ignitor that I need. The one I have for some reason does not fit.....I think my last mechanic tried to use an MR2 connector plug wire, one end would fit just fine on the ignitor, but the other end won't fit on the distributor cap that I have.

My question is, will an MR2 ignition kit like this work??

IGNITION KIT ON EBAY

If not, then can I order the OEM parts from an Autozone or Advance autoparts? I know I can get it from Toyota, but they always try to charge way too much for everything and they never have the stuff I need in stock.

If you know of any good options, advice, or any kind of recommendations would be greatly appreciated. Thank you in advance!!

-AT

This post has been edited by CelicaSTX02: Dec 11, 2007 - 2:43 PM

[CelicaSTX02]

Here's a picture of the Ignition kit off ebay if you don't want to go to the link:






*The connecting wire that I was talking about that I have is the exact same one as the one shown in the picture of this kit. From my Factory Service manual, it seems that the connecting wire for the All Trac 3sgte is different because both ends have 90 degree angles.....the one I have has only one end with a 90 degree angle and the other one is straight.