6G Celicas Forums

Welcome Guest ( Log In | Register )

> What are the Requirments for changing my struts, New KYB's and S-Techs in the mail
post Dec 6, 2007 - 10:32 PM
+Quote Post
k-weaver



Enthusiast
**
Joined Jun 5, '07
From Santa Maria
Currently Offline

Reputation: 1 (100%)




Ok, so I have been wanting to change my suspension ever since I got my car and the time is finally coming. I just purchased and received some KYB GR-2's and my teins are in the mail. I just had a couple of questions on what is needed for the install.

1.) Can I use the orignal stock mounts that are at the top of the strut? (I'm refering to the piece that holds the spring on from the top end)

2.) I noticed that someone else recently did an install of the same set up and he used what appeared to be a rubber piece on the strut. Right where the spring would sit on the strut (bottom of strut), are these necessary?

3.) How hard are these bolts going to be to get off?

4.) Is there a certain way you need to place the spring onto the strut? Or can you just slap it on there?


--------------------
IPB Image
 
Start new topic
Replies
post Dec 11, 2007 - 11:05 PM
+Quote Post
Celicam8

Enthusiast
***
Joined Nov 17, '07
Currently Offline

Reputation: 0 (0%)




when i was replacing my junk, i found my wheel tie rod possible THE best tool if you dont have a breaker bar... i only found this out on the last wheel when i had to fix a stupid mistake i made... I have the 4 different siezed ones, so im not sure if ours fits... ill find out tomorrow...

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: July 24th, 2025 - 3:38 AM