6G Celicas Forums

Welcome Guest ( Log In | Register )

> gauge installation, Air fuel ratio and voltmeter installation
post Dec 29, 2007 - 1:00 PM
+Quote Post
Jeunesse



Enthusiast
***
Joined Aug 21, '07
From Toronto
Currently Offline

Reputation: 1 (100%)




Is there any write ups in here on how to install the Air fuel ratio and voltmeter gauges? If none, can somebody who knows how provide a simple step by step instructions. It might not be that hard to install these but it would be a great help for newbies like me wink.gif .

thanks guys IPB Image
-Derick


--------------------
-Derick

"In hoc signo vinces." In this sign thou shalt conquer."

Gone but never forgotten....
 
Start new topic
Replies
post Dec 30, 2007 - 12:23 PM
+Quote Post
stetsonaw



Enthusiast
*****
Joined Aug 3, '07
From Bellevue, Nebraska
Currently Offline

Reputation: 28 (100%)




i installed my a/f gauge the same time i installed my oil pressure gauge. i figure i tapped into the wrong wire on the o2 sensor, and i don't have a constant reading. it flashes the reading, then shuts off. not bad power, just bad signal. on my o2 sensor, there are 2 ground leads, a power lead, and a signal lead. tap into the wire on the backside of the harness, not the wires directly on the o2 sensor. autometer's website has manuals for each of their gauges. just find the gauge on their site, and on the page for that gauge, there should be a link for an instruction manual.


--------------------
~Andy
Twin '95 3S-GE's - SS-III & Curren '08 Mazda3 Axela i Sport - "Zoom Zoom"

Check out my Droid Goodies
| My Flickr

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: July 24th, 2025 - 2:05 PM