installed Injen intake today. Need some assistance. Options

[JasonX]

Hi everyone! Installed my Injen intake today. But, gotta few questions. On the directions it is talking about a "stock check valve", which was suppose to be on my old intake duct. When I looked at my old one, that hose wasn't there. There was a bolt covering it instead. So, I couldn't put that valve where I put the "blue question mark". Is it real necessary? If so, i'll go get one. Also, it mentions to plug the stock vacuum hose over the 3/8" nipple under the intake by the T/B. Is that where I put the "red circles"? The 2 red circles are the same line. it connects from T/B to the small diameter pipe under the intake. The "yellow line" is where the line used to be before the Injen. Please look into how I did it and let me know if it is correct. Also, does this intake just sit in there or does it require any other type of securing?

thanks a bunch.

This post has been edited by JasonX: Jan 12, 2008 - 2:32 PM

[pittfirefighter]

you don't have to cap the nipple on the TB, you have two connections on the intake... you cap the nipple on the TB if you only have one on the intake (like cheap ebay ones)... just leave it just like you have it