Parts needed to make a beams 3sge? Options

[GER-CELI]

What parts i need to make my 3gen 3sge to beams?
Or its better to swap?

[pasqual]

What parts i need to make my 3gen 3sge to beams?
Or its better to swap?

I did this swap 4 months ago ...

what you need is :

exhaust Y pipe

and top of air-box ..

if you dont have with beams engine You need MAF sesnsor

swap is PnP ......no problems


1. Air intake + MAF sensor (beams -> right )



2. Y-pipe (beams bellow)






3. You need cut and make longer wiring (about 1m ...RHD to LHD conversion)
(I will make photo later)

I see You are located in Germany ... Im in Brno CZ

This post has been edited by pasqual: Jan 20, 2008 - 12:21 PM

[Kwanza26]

I did this swap 4 months ago ...

what you need is :

exhaust Y pipe

and top of air-box ..

if you dont have with beams engine You need MAF sesnsor

swap is PnP ......no problems

1. Air intake + MAF sensor (beams -> right )

3. You need cut and make longer wiring (about 1m ...RHD to LHD conversion)
(I will make photo later)

I see You are located in Germany ... Im in Brno CZ

Huh???? You don't make sense. I think you misunderstood the question.

Anyway... to make your 3rd gen 3SGE into a beams, you'll need a COMPLETE Beams head with both manifolds and all sensors. You'll need Beams pistons, and finally, the exhaust pipes and intake studd mentioned. It's easier to just swap in a Beams.