7AFTE, Check out page 3, one last question before the car goes to the shop Options

[mikecelica]

Few questions i had about the 7AFTE setup:

1. Is a .45 trim t3 turbo ok size or too small? Lookng to make about 180hp or so
2. Is 3" exhaust too big, shud I go with 2 1/2?
3. Do i need an fmu if im gona use bigger injectors?

thanks for any help

This post has been edited by mikecelica: Feb 24, 2008 - 2:35 PM

[trd94]

ok the probe injectors well work,but you well need to get the pigtails for them,so you can wire them into your harness. a t3.45trim is small ,but you wont have much lag, and it should make the power goal you are after. go with 2 1/2 exhaust all the way along with intake pipe as well. if you are running a auto tranny with this setup you might be close to hitting a 14.7-14.9, but more than likly a 15-15.5 as you will have alot of torque steer in the 1/4 mi times, and traction will be a issue. a fmu will not work well for your hp goal,and you can use the same fpr, and spark plugs. i woulg go a step colder but you dont need to. always run ngk they work the best. dont forget to upgrade the fuel pump ,and i would us the emanage to get a better tune. it will help with the timing under boost. hope this helps you a little.

This post has been edited by trd94: Feb 13, 2008 - 5:59 PM