Lets talk body kits~ Options

[D-Man]

okay, i know this is covered in the sticky; "The more you spend the better"

However; out of a few brands, i am trying to figure out witch i am going to purchase. I'm looking for the Blitz front with the invader sides and rear. Now, i WILL NOT buy theese off of ebay. Yeah i could get em for 100 bucks, but will it be anything decent? NO~

Body-Kitz.com offers a nice selection, but due to the fact they wont even give you the name of the manufacturer, I dont really want to trust them to deliver a quality product. Plus One member of this fourm (I forget the name) had a really bad experience with Body-kitz.com.

So I've been looking at Andy's wares, and it would seem there are a few good buys. I dont want to spend $1000 for this... So my question is if anyone has any experience with the following manufacturers:

AIT Racing - VS
Duraflex - Extreme Dementions
VFiber - Vision

Or look for yourselfs here:

http://www.andysautosport.com/toyota/1994_...rior/body_kits/

So if anyone has an opinion on theese 3 brands, i would love to hear all feed back possible.

[Sh0gunkid8721]

For the Blitz, i would just get the ebay kit because wherever u get em, its a nightmare to install from what i hear. Lots of bodywork involved where the side meets the fender. either ur gonna have to cut some of the fender or do somethin else with it. Its probably just as bad as the Combat kit. Besides i think its the ugliest kit for the Celica yet.

[D-Man]

For the Blitz, i would just get the ebay kit because wherever u get em, its a nightmare to install from what i hear. Lots of bodywork involved where the side meets the fender. either ur gonna have to cut some of the fender or do somethin else with it. Its probably just as bad as the Combat kit. Besides i think its the ugliest kit for the Celica yet.

i wonder if anyone on this fourm has installed one? It looks like it'd go over the fender, to give it that extra bulked up look, (And that's obviously the point of a blitz kit; looking bulky.) and i'm guessing that it secures where the fender meets with the splash guards, and if it dont, Then that'd be a good place for me to fabricate in a secure tab; assuming that said peice will cover the fender without bending outward on the upper section of that peice... (Side vent area)

Has anyone here ever installed a blitz kit? I also believe that the invader kit does the same, but not sure... i'll edit this out if it dosent.