How to build a patch that will last :) Options

[speedfeen]

In this case the hole is in the floor 3 layers deep, including a re-inforcement piece for the rocker!


Alright before you start cutting out and getting ready for a patch you have to make sure you have the right tools for job as well as equipment!

A welder , welding gloves, shield/blanket & helmet, fire extinguisher (in case you light something on fire ), safety glasses, clamps, pencil & paper to write down your measurements(or in my case paper towel), sheet metal (20 & 16 gauge), side cutters, grinder, non-latex gloves, pick hammer, light (if needed), tin snips, epoxy primer, sealer, die grinder, measuring tape, tape, dolly or anvil, and whatever else you may think you'll need.











This post has been edited by speedfeen: Mar 18, 2008 - 1:15 PM

[presure2]

great work.
i would really like to see some work on a 6th gen tho.
i love the example shown, and how the work is done, but technicly this thread "should" be moved to off topic.
ill leave it, just because of the excellent example it shows. (just make the pics bigger!)

[speedfeen]

great work.
i would really like to see some work on a 6th gen tho.
i love the example shown, and how the work is done, but technicly this thread "should" be moved to off topic.
ill leave it, just because of the excellent example it shows. (just make the pics bigger!)

it wouldnt let me post all my pics :S



but i can post my photobucket so you can see all the pics, some bigger some smaller


hows that?




ALTHOUGH the rockers need to be replaced on the car...and when I do that I will post lost of pics



feen

This post has been edited by speedfeen: Mar 19, 2008 - 10:30 AM