 Colt Cams, What can these do for me |
 Apr 1, 2008 - 8:45 PM
|
 
|
|
Enthusiast  Joined Jan 20, '08 From East Coast Currently Offline Reputation: 1 (100%)  |
I emailed colt cams for the 294 grind...they don't do it but offered this instead...
256° .330 Lift – the cost for this one is $350.00 260° .345 Lift – The cost for this one is $400.00 What can this do for me? |
 |
Replies
|
Apr 6, 2008 - 1:47 PM
|
|
|
Enthusiast Joined Jan 20, '08 From East Coast Currently Offline Reputation: 1 (100%) |
I think that $350 is for one cam, Bccentaur3.
So the 256's...I should get a 256 intake and 260 exhaust? I want to keep as much low end power as possible and gain some upper end power "if" possible. Point being I want more torque basically and I want it all from the lowest possible rpms to about 5K. Anything gained "after" that is a plus but not too important to me. This post has been edited by 6G96GT: Apr 6, 2008 - 1:47 PM |
Posts in this topic
6G96GT Colt Cams Apr 1, 2008 - 8:45 PM
Cuts_the_Pilot this is for a 3sge im assuming.
they dont run muc... Apr 1, 2008 - 8:54 PM 6G96GT did you order your hks 264 for strictly the celica... Apr 1, 2008 - 8:55 PM bccentaur3 I emailed colt also, but so far no response. What ... Apr 1, 2008 - 8:58 PM Cuts_the_Pilot you order to suit your engine.
so in my case gen 3... Apr 1, 2008 - 9:03 PM politicsareevil I am looking into getting those same HKS cams for ... Apr 1, 2008 - 9:09 PM
6G96GT QUOTE(politicsareevil @ Apr 1, 2008 - 9... Apr 2, 2008 - 8:16 PM bccentaur3 QUOTE(6G96GT @ Apr 1, 2008 - 8:45 PM... Apr 1, 2008 - 9:11 PM 6G96GT QUOTE(bccentaur3 @ Apr 1, 2008 - 9:1... Apr 2, 2008 - 1:24 PM Cuts_the_Pilot same as with any car with cams
expect (with say ... Apr 2, 2008 - 3:01 AM chacha what do you need to get the response and pull at ... Apr 2, 2008 - 8:29 PM Cuts_the_Pilot want power low and high? buy a car with vvtl-i oth... Apr 2, 2008 - 9:44 PM presure2 QUOTE(6G96GT @ Apr 1, 2008 - 9:45 PM... Apr 4, 2008 - 4:36 PM chacha thanks for ya'll info...i greatly appreciate i... Apr 4, 2008 - 8:17 PM bccentaur3 Geoff gave me the same pricing for the cams. Now I... Apr 4, 2008 - 10:57 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: July 29th, 2025 - 10:54 AM |