where do the ABS sensor wires run to? Options

[CelicaB]

So on my project car, someone cut a rear abs sensor wire, because they needed the sensor I imagine. Only they didn't just take the sensor off at the plug, they cut the wire around the firewall I think. I don't have acces to a manual or anything down at school, but was wondering if anyone had a diagram or pictures of where the rear wires run to? (from the abs block back would be great) Also is this whole assembly something I can order from the dealer? (sensor all the way to the block?)
thanks
-Bryan

This post has been edited by CelicaB: Apr 17, 2008 - 11:13 AM

[94TRDcelica]

I recently did my front ABS sensor! Don't quote me but it should eba similar set up i'd imagine!

Basically the sensor runs from just above the wheel hub, behind the caliper, around the strut and up into the wheel arch. Pull back the plastic of the wheel arch, you may need to unbolt it, and there should be a connection. The replacement sensor comes with the loom and this simply plugs into the existing link in the wheel arch (Hidden) then bolt it up and plug the sensor into its housing - done - 20mins tops!!!! The rest of the wring will run internally!!!

You should be able to order the sensor and loom from your local toyota dealer!