6G Celicas Forums

Welcome Guest ( Log In | Register )

> My Project Thread!!!!, 94 celica GT Import ST202
post Apr 17, 2008 - 7:31 PM
+Quote Post
94TRDcelica



Enthusiast
*
Joined Feb 4, '08
From UK
Currently Offline

Reputation: 0 (0%)




Hi guys, ive been on here a while and decided to post my project thread, im a member of UK forum primarily for jap cars so Ive jsut copied and pasted it over - What do you think?

Thought I'd start a project thread for the celica as I seem to have an endless amount of stuff that I want to do to her! Enjoy!!!

1. Dynamat the rear and sorted a few rattles in the rear quarter panels!
IPB Image

2. new alpine speakers for the rear.
IPB Image

3. New HKS air filter
IPB Image

4. Oil catch can.
IPB Image

5. Cleaned cams up, painted rocker and manifold. TRD oil filter, castrol magnatec oil, oil pressure gauge, water temp gauge and volt meter on A-pillar pod (I will get pics of these when I remember next)
IPB Image

6. Exhaust heat wrap. Getting the heatshield chrome painted soon!
IPB Image

7. Cleaned Intake manifold adn throttle body - they were full of carbon S**t!
IPB Image
IPB Image
IPB Image

8. Cleaned and painted distributer
IPB Image

9. New fan belt and power steering belt. lightweight pulleys are on the agenda. and need to loosen belts as they are squealing on full lock!
IPB Image

10. Custom CAI created and installed, a definate increase in throttle response and noise. :rock:
IPB Image
IPB Image
IPB Image
IPB Image
IPB Image
IPB Image
IPB Image
IPB Image



11. TRD thermostat installed, compare it to the original one. Also TRD radiator cap.
IPB Image
IPB Image
IPB Image
12.


And finally my GT4 rear strut bar, got it for a bargain off fleabay!
primed
IPB Image
Painted
IPB Image
Installed, with finishing touches of stickers :rock:
IPB Image
IPB Image
IPB Image



I then proceeded with the interior!!!!!

1: original ring
IPB Image
2: green condom thing on boring bulb.
IPB Image
3: 2x BLue 12v led's, 2x transistors, shrink wrap, and the bulb holder.
IPB Image
4: Soldered the bulbs and transistors in place.
IPB Image
5: created the loom.
IPB Image
6: Done!
IPB Image

Changed the bulbs behind the dash to white led's then changed them again to differnet led's that emit wide angles of white light!!!!
IPB Image
IPB Image
IPB Image

Changed the bulb around the cigarette lighter to a blue led, this was tricky becasue its so small and getting the right amount of light in without the lighter when switched on casuing a fire :lol: that would be an expensive mistake for a small mod!
IPB Image

Next I wanted the change the bulb's behind my AC control unit to blue Led's.

1: This is the circuit board - I added three wide angle blue led's. Plus changed the orange screen heater buttons to red led's (Top). And made a mini circuit board to hang down for intense side on lighting. (Nicked from a fibre optic lamp). This was reeally hard and made a few mistake burnign holes in the board but its all working fine now!!!!!
IPB Image

2:And this is how it now looks at night - cool huh? I also changed the clock colour to blue by using a blue plastic filter screen and removing the original horibble brown piece.
IPB Image
IPB Image



Kirkosaurous Motor Mounts - Also new clutch and machined flywheel - Forgot to take pics though!!!!!
IPB Image
IPB Image

More Led's, this time in the door handles and in the door pockets. I wired them into the window lock button so they can be switched off just in case coppers don't like it!
IPB Image

Heatshields and custom radiator cooling plate back from Powder Coating! Fitted and sticker'd - looks so much better under there now!!!!
IPB Image
IPB Image
IPB Image


So ive been a busy bee recently. Yesterday, after the rain the weather was quite nice so I decided to wash, clay, detail and wax/polish all over in preparation for the new skirts.

IPB Image
IPB Image
IPB Image
IPB Image

I even Polished my exhaust - I'm having a midlife crisis, LOL!
IPB Image




Today I fitted GT4sideskirts, I think they might me TRD ones but not sure, they are definately not standard celica skirts as they reach higher up on the body of the car compared to stock skirts - They look very similar to the C-one ones without the indents!!! Anyway here are the photos for the job.

Skirts, in need of repair:
IPB Image

Sanded and wet rubbed, rubber compound rubbed and fine crack filled:
IPB Image

Had a few fibreglass patches to fix:
IPB Image

Primed:
IPB Image

Painted:
IPB Image

After much debate I decided to give the lacquering a shot, was quite chuffed with the reuslts:
IPB Image

Took about 2 hours to prep them, check alignment, drill holes etc but its finished at last and very ahppy with the reults. They need to be blended a little, and a small section needs to be stuck closer to the body but overall I am quite happy, sets the cars stance of quite nicely!!!

IPB Image
IPB Image
IPB Image
IPB Image

Cleaned over again and all finished, just cracked open an ice cold beer and basking in the sun marvelling my work B) :lol:

IPB Image


My next project is tyres and suspension (once it's got through the next MOT! biggrin.gif )

Thanks for looking :wave:


--------------------
IPB Image
 
Start new topic
Replies
post Apr 17, 2008 - 8:11 PM
+Quote Post
99GT

Enthusiast
****
Joined Dec 14, '06
From MN, USA
Currently Offline

Reputation: 2 (100%)




thumbsup.gif thumbsup.gif thumbsup.gif thumbsup.gif thumbsup.gif thumbsup.gif thumbsup.gif thumbsup.gif

Looks really really good!

Posts in this topic
- 94TRDcelica   My Project Thread!!!!   Apr 17, 2008 - 7:31 PM
- - 99GT   Looks really really good!   Apr 17, 2008 - 8:11 PM
- - Valo666   wow..nice work man. looks like youve been pretty b...   Apr 17, 2008 - 8:18 PM
- - Mangozac   Great stuff. I'm picking up some strut bars so...   Apr 17, 2008 - 8:53 PM
- - tomazws   Awesome job painting your skirts!~   Apr 17, 2008 - 9:34 PM
- - supershannon77   Awesome work..you put a lot of time and effort int...   Apr 17, 2008 - 9:38 PM
- - Batman722   looks great, some nice mods there QUOTE now the...   Apr 17, 2008 - 11:28 PM
|- - Insanity-74   QUOTE(Batman722 @ Apr 18, 2008 - 5:2...   Apr 18, 2008 - 1:10 AM
|- - tomazws   QUOTE(Insanity-74 @ Apr 17, 2008 - ...   Apr 18, 2008 - 12:45 PM
|- - Batman722   QUOTE(tomazws @ Apr 18, 2008 - 1:45 ...   Apr 18, 2008 - 3:34 PM
|- - snapshotgt   QUOTE(Batman722 @ Apr 18, 2008 - 3:3...   Apr 18, 2008 - 3:41 PM
- - _mikeE   Awesome work man, your engine bay looks soo clean.   Apr 17, 2008 - 11:28 PM
- - 94TRDcelica   Thanks or the comments - Its a work in progress...   Apr 18, 2008 - 5:44 AM
- - D-Man   Beautiful. Simply Amazing. 2 Woots for you!   Apr 18, 2008 - 1:48 PM
- - manphibian   Some great work, engine bay looks amazing! I...   Apr 18, 2008 - 3:54 PM
- - l19tly   nice work mate! have you managed to find a li...   Apr 18, 2008 - 5:24 PM
- - dtlwrc   What a great job... Your car looks great! I lo...   Apr 18, 2008 - 5:55 PM
- - joehernandez   QUOTE(Batman722 @ Apr 18, 2008 - 3:3...   Apr 19, 2008 - 1:51 AM
|- - 94TRDcelica   QUOTE(joehernandez @ Apr 19, 2008 - 1...   Apr 19, 2008 - 2:58 PM
- - Jared95   Wow very nice...lots of time ...motor is super cle...   Apr 19, 2008 - 10:23 AM
- - bizzerk   that trd wing is sex bro so is the rest of your ca...   Apr 21, 2008 - 8:40 PM
|- - an02   QUOTE(bizzerk @ Apr 22, 2008 - 1:40 ...   Apr 23, 2008 - 4:57 AM
|- - 94TRDcelica   QUOTE(an02 @ Apr 23, 2008 - 4:57 AM)...   Apr 23, 2008 - 11:40 AM
- - 94TRDcelica   Just done a compression test and got 170.170.170.1...   Apr 27, 2008 - 6:31 AM


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: August 19th, 2025 - 2:04 PM