where do the ABS sensor wires run to? Options

[CelicaB]

So on my project car, someone cut a rear abs sensor wire, because they needed the sensor I imagine. Only they didn't just take the sensor off at the plug, they cut the wire around the firewall I think. I don't have acces to a manual or anything down at school, but was wondering if anyone had a diagram or pictures of where the rear wires run to? (from the abs block back would be great) Also is this whole assembly something I can order from the dealer? (sensor all the way to the block?)
thanks
-Bryan

This post has been edited by CelicaB: Apr 17, 2008 - 11:13 AM

[Paul_Celica_GT]

The wiring of the rear ABS sensors runs trough the main compartment wire through connector IH1 (somewhere behind the dashboard) to the ABS ECU. On my website you can download the ST205 body repair manual. At the end of that document are the ST205 Electrical Wiring Diagrams. On page 239 is the ABS scheme, which is the same for ST20x and AT200. Colors of the wires are explained on page 312. Download the BGB here (Right mousebutton, "Save target as...") from my site, Celica GT.nl.

Might be the best to run your own wires, and solder them to the wires right for the ABS ECU. That way, you won't have to search for the wires.

Good luck.