 3sgte vac/coolant lines, from/to where? |
 May 4, 2008 - 10:04 PM
|
 
|
 Enthusiast  Joined Jan 13, '06 From UnderTheGround403 Currently Offline Reputation: 2 (100%)  |
Where does this vac line run to/from? The one with the phillips pointed at it. It is labelled "3" and goes from the intake manni to a metal bracket attached to the fuel rail. I'm 99% sure it attaches to a T coming from my FPR, and shoule look like the 3rd pic. Is that correct? Can I eliminate the meat bracket attached to the fuel rail, and just run vac line from intake manni to the T?
   And these coolant lines run to the TB. Which one attaches to which nipple?  |
 |
Replies
|
May 6, 2008 - 7:22 PM
|
|
 Enthusiast Joined Aug 31, '02 From Philadelphia, PA Currently Offline Reputation: 8 (100%) |
QUOTE(6gsillyca @ May 6, 2008 - 12:21 AM) [snapback]671017[/snapback] How hot does it get next to the fuel rail? Would my rubber vac line be ok if I just ran it where the metal one was? Hard to tell. It gets pretty hot there, but then again that hose can take some heat. If i were you i would route it away from anything and take the tee off. The fpr vac line is REALLY important. -------------------- 15PSI - 30MPG - Megasquirt Tuned
|
Posts in this topic
6gsillyca 3sgte vac/coolant lines May 4, 2008 - 10:04 PM
lagos That vac line goes to a metal tube, that then goes... May 4, 2008 - 10:15 PM 6gsillyca Thanks. I wasn't sure if the metal tube was si... May 4, 2008 - 11:39 PM lagos QUOTESo the coolant there isn't a "feed... May 4, 2008 - 11:44 PM 6gsillyca How hot does it get next to the fuel rail? Would m... May 5, 2008 - 11:21 PM 6gsillyca I was probably going to route it along the firewal... May 6, 2008 - 11:53 PM lagos It goes to your greddy boost controller.
I never ... May 7, 2008 - 12:00 AM 6gsillyca What should I use to re-tee into? I don't know... May 7, 2008 - 1:09 AM
lagos The round thing is just a filter.
You can use any... May 7, 2008 - 11:32 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: January 17th, 2026 - 10:48 PM |