May 28, 2008 - 9:06 AM
|
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Jan 10, '04 From Shoreline, WA Currently Offline Reputation: 4 (100%) |
Well I finaly figured out my cars electrical problems (would not do anything no spark at first then no crack at all, found a few lose connections in the main fuse box that were to blame as well as my alarm wiring that was causing it to disable the ignition, and a few bad relays
Any thoughts, I'm so close to getting this mess done I can taste it. -------------------- ![]() |
![]() |
May 28, 2008 - 11:59 AM
|
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Jan 10, '04 From Shoreline, WA Currently Offline Reputation: 4 (100%) |
TDC? the cams are in the right place as far as I know will check, I did not swap them or the timing belt. and the motor was in running condition when I bought it, fully tested and compression was good.
edit: TDC or Top Dead Center, pretty sure it was not but should not matter as nothing mechanicly changed on the motor, I swap the distributar but I'm positive its in correctly and in the exact pos the old one came out. This post has been edited by creis: May 28, 2008 - 12:08 PM -------------------- ![]() |
creis Engine trouble; wont start May 28, 2008 - 9:06 AM
95CelicaST Are the cams in the right position? Was the motor ... May 28, 2008 - 11:47 AM
creis cause:
Timing was ahead 5 degrees, Maf was connect... May 29, 2008 - 9:05 AM
stephen_lee yeah i was going to suggest your ignigion timing m... May 29, 2008 - 10:06 AM![]() ![]() |
| Lo-Fi Version | Time is now: November 22nd, 2025 - 2:43 AM |