Fuel rail removal/install Options

[6gsillyca]

OK so, I swapped my injectors out, but now have a massive air leak coming from the rail itself not being seated properly. I'm not 100% sure of how many/what o-rings/spacers/insulators are needed to properly RnR the rail, so does anyone have a diagram of the rail/injectors and ALL the parts needed to RnR it, and where which parts should go?

I did the 2 bigger o-rings on the injectors themselves when they were out, but that was it.

For parts I have to order from toyota I have:

23291-75010 x 8 (injector insulator/FR cushion)
23845-88380 x 4 FR to head insulator
90561-08032 x 3 FR spacer


Would that be all? I just want to make sure I get everything the first time.

This post has been edited by 6gsillyca: Jun 3, 2008 - 10:42 PM

[6gsillyca]

Is there any sort of diagram on the bgb of all of these parts and where they go?

When I took my old injectors out I'm not 100% sure of which o-rings/insulators were supposed to go where, as some got knocked off when I took the old rail out.

I am going to order all 3 sets, just because I would rather have them and not need them, but do not know where everything goes.


Def,

Where are the o-rings you are talking about? Where do they attach to the fuel rail?

This post has been edited by 6gsillyca: Jun 3, 2008 - 10:33 PM