![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() Joined Jun 10, '08 From Virginia beach Currently Offline Reputation: 8 (100%) ![]() |
Hey, so my 94 St is havin a small electrical issue. My Open Door light stays on 24/7. Even with car off and both doors shut. I checked both sensors and did everything I can to stop it...but the light stays on. Is there any way to override this. Possible a wire to cut or a fuse to pull?
Thanks guys -------------------- |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Mar 15, '07 From Tennessee Currently Offline Reputation: 52 (100%) ![]() |
probably your sensor/switch does not work anymore. you need to pull both out and try to disconect them see waht happens. that will drain your battery.
-------------------- Learned a lot in 10 years... I hardly log in anymore, last login Today Sept 6 2019, and I was forced just to clarify a post. LOL
If you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in 2grfe Swapped... Why I chose the 2GR, before you ask read here... A great civilization is not conquered from without until it has destroyed itself from within. @llamaraxing in Instagram is the best way to find me. I hardly log here anymore. |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Apr 2, '07 From Great Western Plateau Currently Offline Reputation: 9 (100%) ![]() |
The sensors are just momentary switches, a simple close and open circuit. (diagram)
*The pinhead connects to the chasis thus acting as the neg terminal. The wire going from the bottom up to the latch is from the bulb. When you open the door the latch touches the black pinhead and this completes the whole circuit, when you close the door the latch is pushed away from the pinhead an this breaks-up the circuit. For it to stay on all the time means the wire that goes to the M switch must have touch the ground continously even after you push the latch away from the pinhead. So either the lilttle rod that pushes the latch away from the pinhead is broken or the wire goes to the M switch broke and felt off touching the chasis. Hope this helps. -------------------- ![]() 98% completion --- aaRon |
![]() ![]() |
Lo-Fi Version | Time is now: June 3rd, 2025 - 6:13 AM |