HID H3 Problem, Flickering - Important if you plan to get HIDs. Options

[trdproven]

Hi - Trying to figure out why my HID's flicker and then shut off. First of all, since H3 HIDs have many wires as compared to a factory halogen with 1 wire I can close the OEM cover but with HIDs I cannot close the cover because of the more wires running to the ballasts. How did you guys run yours? Getting into my real issue, my first thoughts on the problem is that I might not have a good ground. I can also try switching ballasts around, set up dedicated grounds for each side, turning on the car for more power, or wire both negative and power from the HID bulb bypassing the OEM harness on the backside of the fog. Any ideas or experiences anyone might have, I already wasted my money on H3 LED's, they are white but not bright. I really need a true and sureshot way of installing H3 HIDs. Thanks in advance.

This post has been edited by trdproven: Aug 2, 2008 - 3:55 AM

[trdproven]

Figured out the problem, there was two. The first was I was not getting a good ground so I ran a direct cable from my battery and it turned on with the bulb not in the fog yet. So I put the bulb in the fog and it did not turn on. So I began the switching of ballasts and bulbs still the same. So I took the bulb out again and turned it on and it lit up. It came to my conclusion that there is a double ground, one from my direct wire and one in the fog light. So I disconnected the female from the fog light and plugged my hid bulb negative spade into that and it turned and lit up. So I did away with the direct wiring, which makes things neater and I wasted money buying stuff to test with. But thanks all for the help - I think with all the research i've done on it, I'm a pro now with all the different issue factors.

Also - found one ballast defective.

This post has been edited by trdproven: Aug 2, 2008 - 3:56 AM