![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Jan 31, '07 From Ontario, Canada Currently Offline Reputation: 1 (100%) ![]() |
I just picked up an alpine deck CDA-7894. There are no place for RCA cables on the deck, anyone know how this works? I need the RCA plugs for my amp.
thanks for any help. ![]() |
![]() |
![]() |
|
Enthusiast ![]() ![]() Joined Dec 19, '02 From West of Atlanta Currently Offline Reputation: 1 (100%) ![]() |
I think I found the place where the rca lines WERE. There are 6 (bit thicker than speaker wire) wires all in one harness but have been cut off from the base leaving only .5inch of each sticking out. So should I get some rca wires and just extend them or is it more to it than that? That is / was the rca outputs. Good luck splicing them. There is a center conductor and a shield surrounding it, can be tricky to splice. If I was gonna do it, I would open the case and solder new rca's to the board. |
![]() ![]() |
Lo-Fi Version | Time is now: August 29th, 2025 - 5:39 AM |