Im ready for ROUND 2..., Ninja turtle 2 progress springs/tires Options

[easternpiro1]

Hey guys, thought i would post what ive been up to the past couple of days. Been having some crazy outside issues (dont worry guys in the f/s feeler i didnt forget u)
i made it naked in record time with just a few things left in there.

so i guess we all know whats next...right?













BABY OIL GREASIN HER UP FTW! LOL!



next up...





its in georgia now, and tweak will be doing the wiring and oversight of the swap. lets pray the motor isnt ruined!

This post has been edited by easternpiro1: Sep 13, 2009 - 7:06 PM

[Dr_Tweak]

Hey guys,

As most of you know I do almost only wiring now, I oversee swaps at SCC that are being done on my customer's cars when they need help. My comments on the build:

1. The over-axle was my choice and is by far the best way to do it. It's the way it's ran factory, with mandrel-bent piping the extra couple bends aren't going to hurt the flow and it comes out very clean. The whole "under axle is better" notion comes from lazy/unskilled fabricators who have told their customers that going under the axle is "better", simply because they were either unable or unwilling to do it the right way.

2. Having the wastegate going into one runner was a solution to a logistical problem faced by the guys at SCC who did the build. It wouldn't have been my first choice but seeing the small amount of space they had to work with I can see why they did it that way. The manifold is a SINGLE-entry going to a single-entry turbo, so technically all four runners are in the same chamber, and the pressure in that chamber should be able to vent through the wastegate without causing boost creep. I guess we'll know for sure once it's on the road

3. The intercooler piping easily clears the hood, it's taking the same route that it did when I personally did the swap the first time last year, except that now it's welded

-Doc

This post has been edited by Dr_Tweak: Sep 26, 2008 - 12:46 PM