![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Feb 7, '07 From Portland, Oregon Currently Offline Reputation: 67 (96%) ![]() |
It appears my clutch master cylinder went out. I've replaced the slave cylinder already, so that leaves the MC which I believe is back-bleeding; can somebody point me in the direction of where I might find removal instructions? Or give me a rundown on how to remove the MC? I'm picking up a new one today and intend/hope to install it tomorrow.
Thanks! This post has been edited by GriffGirl: Oct 11, 2008 - 4:31 PM -------------------- ![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Mar 8, '04 From Newport, RI Currently Offline Reputation: 63 (99%) ![]() |
I'm guessing that when you had your clutch changed the seals were either probably pinched or cracked and you've been dripping tranny fluid for a while (also the person who changed it probably used the cheapest stuff they could find).
change your tranny oil, use syncromesh (about $7 a quart at autozone) theres a how-to in the stickies with pics, it's not difficult, you can do it. -------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: August 17th, 2025 - 11:41 PM |