5sfte map sensor issue, tech help Options

[94silverbullet]

I'm trying to get my car on the road again. I have already installed the turbo, exhaust, A/F ratio and boost gauge, helicore ignition wires, oil line, FM inthercoolerand piping, and new plugs gapped to .030.
Things to do:
7mge injector-will arrive tomorrow
MSD 6 BTM- tach harnes adjuster is on the way
2 Bar Map Sensor!
I have been trying to get a 2 bar map sensor installed, but the PN in the sticky is invalid according to the dealership I asked; "2 bar MAP sensor(part# 84420-17030)". I asked about the MAP Sensor for the turbo 93 celicas and he said he cannot look them up without a VIN. I called back a couple of times and had no luck gettin it from the dealership.
So I was on another forum that told me the GM 2 bar map sensor would work.
It doesnt. My car will go to idle but if you touch the gas at all the car trys to stall.
The car ran to the point were I could rev and was only an issue at high rpms or WOT before I had the GM 2 bar MAP sensor.

How can I get the correct 2 bar map sensor that my ecu can understand?

[94silverbullet]

okay, I'll make sure the 255lph walbro GSS-342 is in before I hit the road.
Before you switched to the emanage ultimate did you by chance have any rough setting (A/F ratio setting wise) that I could use to get a good start?
It seems like all safc stuff was on n/a cars but you had yours in before you upgraded to the ultimate right? I just want to get it to survive until Christmas when I can actually have time to play with it and optimize settings for performance.
I definitely rushed into this, big mistake

[presure2]

okay, I'll make sure the 255lph walbro GSS-342 is in before I hit the road.
Before you switched to the emanage ultimate did you by chance have any rough setting (A/F ratio setting wise) that I could use to get a good start?
It seems like all safc stuff was on n/a cars but you had yours in before you upgraded to the ultimate right? I just want to get it to survive until Christmas when I can actually have time to play with it and optimize settings for performance.
I definitely rushed into this, big mistake

i used it for 2+ yrs and shannons car makes 285whp with it.

as for settings no,i dont remember what mine were, but i can tell you if you use the 460 rx7 injectors, like you should be, you will be pulling lots of fuel out.