which bolts, when reassembling car Options

[playr158]

I'm going to start with mostly/all new bolts.

reasons being:

a) I don't know what goes where
b) I've lost that particular bolt
c) Its old nasty/rusted/gooey

d) all the above

now I have choices on what kinda bolt I can use

normal


or
socket cap type (the one on the left)



which would you chose. also remember i'm only putting about 1/2 the bolts back in the car that came out of it

thanks

This post has been edited by playr158: Dec 4, 2008 - 11:08 AM

[brthrurik]

The only problem with T-handles is you need pretty good clearance to get into the bolt. Not always the case in an automobile. so use hex head in close tolerance locations and soket cap everywhere else...

This post has been edited by brthrurik: Dec 4, 2008 - 11:27 AM