So I Installed the rear Eibach Camber kits, Whats the OEM Camber in the rear? Options

[njccmd2002]

Im pleased with the results so far. Putting these suckers is a PITA.



Pulled the upper bolt out with this...



then inserted the kit and aligned it where i wanted....



i had to untorque the bottom one, so that i can adjust it. I just guesstimated by moving this line to match the struts. this is where the lines did not meet. in the Above pic I had them meet. Not very scientific... then torqued everything back together...



now my rear tires are almost zero camber



while the front ones are negative



What is the camber specs? I will get it aligned, but just wanted to know? the two front tires are next..




This post has been edited by njccmd2002: Jun 1, 2008 - 2:33 PM

[Jaws4God]

I just put mine on this evening, going to get new tires and then alignment tomorrow and pray that everything is perfect and no more crappy wear..


BTW, how do you adjust them? it seemed like as I would tighten they would adjust all the way out but then stop? I figured then'd keep spinning around and you'd just come back again if you went to far, you know what I mean?
(so like as you spin they'd adjust out...then back in... then back out... until you tighten the nut..




Big props to the write up, I was hoping to find something like this and thanks to 6gc.net the guys/girls had it covered.

This post has been edited by Jaws4God: Dec 12, 2008 - 7:39 PM