Reupholstered Door Cards Options

[korban]

The fabric at the top of my door cards was fraying and falling away, so I pulled them off and dismantled as much as I could.



From the back you can see where to undo the door handle.



From the front you can see that the material can have some overlap here.



I peeled off the old fabric and used it as a pattern on some cheap faux suede fabric I bought for NZ$6. I needed roughly 700 x 300mm to have plenty of overlap (I think actual dimensions were 650x220mm). The fabric was 1400mm wide so I only needed a 300mm strip of it.



Checking that the fabric fitted and tucked in correctly.



While holding it in place I folded half over so I could glue the center and work my way to the edges. I used some cheapo spray adhesive that dried too quickly, If I were to do it again I think 3M Spray 77 is the stuff to use. I used a flat head screw driver to work in the edges.

[pittfirefighter]

hmmm.... i redid my door cards a few months back... after sitting in the summer sun... the spray glue i used (3m good stuff) started to remelt and they started to peel off... hopefully yours wont do the same... i am going to try a non-spray style glue on mine...