problems with cv axle...? Options

[grasby]

ok, so i got my new cv axles yesterday
and today i put them in
but heres the catch,
at some point between when i drove it into my shop, to the time that i removed the first axle,
it stopped moving
the enging runs
it shifts fine
butt its just not pulling/moving
it ran fine before i drove it in,
so i know its something i did
i just can figure out what
plz help,
thanks

[grasby]

1. yes, of course i checked the transmisssion fluid, did a visual overlook of the axles.etc...
2., my english is fine, i just have the habit of pushing enter where i would normally pause in a conversation
but to be honest, i didnt think my english would effect the performance of the car, guess that was just my mistake
so while im dotting my "I"'s and crossing my "T"'s
wanna give another suggestion?


when it first happened it was just during a test run, wand it had no fluid in it
ten seconds later i had put the fluid in
(ok, maybe more than ten seconds, those bottles pour slow)
and the same problem still existed

This post has been edited by grasby: Feb 19, 2009 - 8:55 AM