 RODS & PISTONS for the 3SGTE Motor |
 Mar 26, 2009 - 7:42 AM
|
 
|
|
Enthusiast  Joined Jan 14, '06 From New York Currently Offline Reputation: 0 (0%)  |
Hello, everyone. One of my stock rods broke and now I have to pull apart the engine and swap rods and pistons. I don't want to replace them with stock. I need stronger rods & pistons for my 3SGTE motor. Any recommendations as to which ones I should get and from where at a reasonable price?
And is 8.5 - 9.0 compression ration good? I'm just above 400WHP... Thanks much... -------------------- I drive a Celica. Anything "less" is just a car! |
 |
Replies
|
Mar 27, 2009 - 3:49 PM
|
|
 Enthusiast Joined Dec 15, '02 From Tasmania(Australia) Currently Offline Reputation: 0 (0%) |
QUOTE (nemesis @ Mar 27, 2009 - 6:35 AM)  QUOTE (Cuts_the_Pilot @ Mar 26, 2009 - 9:12 PM) how the fnck did you break a stock rod? 'Cause I make over 400WHP... they should last far past 400hp, but ahh well. These things happen. gl with the build. -------------------- ST205 Group A Rallye GT-Four, #61 of 77............600hp GT3582r
GRX133 Toyota Mark X 350s  |
Posts in this topic
nemesis RODS & PISTONS for the 3SGTE Motor Mar 26, 2009 - 7:42 AM
presure2 most guys run either JE or CP or weisco pistons, a... Mar 26, 2009 - 8:29 AM Cuts_the_Pilot how the fnck did you break a stock rod? Mar 26, 2009 - 8:12 PM
nemesis QUOTE (Cuts_the_Pilot @ Mar 26, 2009 - 9... Mar 27, 2009 - 7:35 AM pittfirefighter sure sounds like a bad tune... i am running JE ove... Mar 27, 2009 - 1:38 AM nemesis QUOTE (pittfirefighter @ Mar 27, 2009 - ... Mar 27, 2009 - 7:42 AM lburner http://cgi.ebay.com/ebaymotors/Eagle-Rod-J...sQ5fA... Mar 27, 2009 - 10:32 AM nemesis QUOTE (lburner @ Mar 27, 2009 - 10:3... Mar 27, 2009 - 10:52 AM alltracst185 QUOTE (nemesis @ Mar 27, 2009 - 10:5... Mar 27, 2009 - 11:09 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: September 4th, 2025 - 11:51 AM |