 silly, dumb, clutch linkage question |
 Apr 4, 2009 - 8:02 AM
|
 
|
|
Enthusiast  Joined Jun 25, '06 From Box Elder, South Dakota Currently Offline Reputation: 2 (100%)  |
I have just installed my engine back into my car, and somehow the shift linkage that runs from the shifter to the transmission popped out of the bracket ( when i took the engine out i left it in the bracket) anywho, is there a senseible way to re-attatch it back to the bracket aside from hammering it in...which i have tried and it hastn worked
-------------------- (\__/)
(='.'=) This is bunny. Copy and paste bunny into your (")_(") signature to help him gain world domination. |
 |
Replies
|
Apr 4, 2009 - 4:23 PM
|
|
 Enthusiast Joined Aug 17, '04 From California Currently Offline Reputation: 20 (100%) |
Ohh ok i get it now.... Like bitter just said there needs to be a clip there.
What you do is push the linkage through the bracket's loop until that groove comes out the other end... then just put the "U" shaped clip into that groove to keep the linkage from sliding back out again.  Here is the best picture i could find. the top of the "U" clip is facing the camera. But... Look at the Clutch line, and you can see how it is also held by a "U" clip in the same manner, only its smaller... hope this helps |
Posts in this topic
3WayStunna silly, dumb, clutch linkage question Apr 4, 2009 - 8:02 AM
eggman40 QUOTE (3WayStunna @ Apr 4, 2009 - 6... Apr 4, 2009 - 2:30 PM 3WayStunna well i cant take a pic since my camera is down, bu... Apr 4, 2009 - 3:19 PM Bitter it slides through and is held by a clip, if its no... Apr 4, 2009 - 3:40 PM
Cuts_the_Pilot yep what he said is right.
if your trying to p... Apr 4, 2009 - 5:50 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: September 22nd, 2025 - 12:33 AM |