 3S-GTE Gen 4 Check engine light problem |
 Apr 28, 2009 - 8:54 PM
|
 
|
 Enthusiast  Joined Mar 11, '09 From Baltimore, Maryland Currently Offline Reputation: 1 (100%)  |
Hi all, Two days ago the check engine light came on. When I drive for 5 min the light comes on.
 I have a 3sgte out of a Caldina (ST215) and the use the stock JDM ECU, so I can't get codes from it. I don't see anything leaking and the car runs great. I have put about 800 miles on the car since i did the swap. What should I check first? |
 |
Replies
|
Apr 30, 2009 - 8:40 AM
|
|
 Enthusiast Joined Mar 31, '04 From Summerville, SC Currently Offline Reputation: 5 (100%) |
There's no Diag box on the ST215 harnesses, that's why I was asking if we did the harness, we normally add in a diagnostic wire when we do them. Hopefully the OP comes back
 -Doc -------------------- -Dr Tweak, 6GC's resident engine swap wiring expert extraordinaire Click here to see my swaps drtweak@phoenixtuning.com |
|
May 1, 2009 - 7:17 AM
|
|
|
Enthusiast Joined Mar 11, '09 From Baltimore, Maryland Currently Offline Reputation: 1 (100%) |
Doc, you did an excellent job on my harness. Remember, it went right in with no issues. The light only cut on a few days ago.
The car runs great. I don't see any performance issues at all. QUOTE (Dr_Tweak @ Apr 30, 2009 - 8:40 AM)  There's no Diag box on the ST215 harnesses, that's why I was asking if we did the harness, we normally add in a diagnostic wire when we do them. Hopefully the OP comes back -Doc |
|
May 1, 2009 - 3:14 PM
|
|
|
Enthusiast Joined Mar 31, '04 From Summerville, SC Currently Offline Reputation: 5 (100%) |
QUOTE (speed-CCNP @ May 1, 2009 - 8:17 AM) Doc, you did an excellent job on my harness. Remember, it went right in with no issues. The light only cut on a few days ago. The car runs great. I don't see any performance issues at all. QUOTE (Dr_Tweak @ Apr 30, 2009 - 8:40 AM) There's no Diag box on the ST215 harnesses, that's why I was asking if we did the harness, we normally add in a diagnostic wire when we do them. Hopefully the OP comes back -Doc Ah you should have just called me then There should be a wire located near your ECU with a label on it that says "Diagnostics". Ground that wire to run the trouble codes. If you do NOT have that wire, give me a call or email and I'll walk you through what you need to do. -Doc -------------------- -Dr Tweak, 6GC's resident engine swap wiring expert extraordinaire Click here to see my swaps drtweak@phoenixtuning.com |
|
May 3, 2009 - 9:02 PM
|
|
|
Enthusiast Joined Mar 11, '09 From Baltimore, Maryland Currently Offline Reputation: 1 (100%) |
 Cool, I'll give you a call  QUOTE (Dr_Tweak @ May 1, 2009 - 3:14 PM) QUOTE (speed-CCNP @ May 1, 2009 - 8:17 AM) Doc, you did an excellent job on my harness. Remember, it went right in with no issues. The light only cut on a few days ago. The car runs great. I don't see any performance issues at all. QUOTE (Dr_Tweak @ Apr 30, 2009 - 8:40 AM) There's no Diag box on the ST215 harnesses, that's why I was asking if we did the harness, we normally add in a diagnostic wire when we do them. Hopefully the OP comes back -Doc Ah you should have just called me then There should be a wire located near your ECU with a label on it that says "Diagnostics". Ground that wire to run the trouble codes. If you do NOT have that wire, give me a call or email and I'll walk you through what you need to do. -Doc |
Posts in this topic
speed-CCNP 3S-GTE Gen 4 Check engine light problem Apr 28, 2009 - 8:54 PM
alltracman78 You have to check the codes, otherwise you're ... Apr 29, 2009 - 7:46 AM malpaso check air sensor (measuring amount of intake air).... Apr 29, 2009 - 7:55 AM
speed-CCNP The air sensor can go bad?
QUOTE (malpaso @ ... Apr 30, 2009 - 8:38 PM pitcelica did you bought a complete engine or a front clip f... Apr 29, 2009 - 9:27 AM speed-CCNP I buy a clip. I didn't install OBDII connecto... Apr 30, 2009 - 8:29 PM speed-CCNP I still have the clip. Is there something I need ... May 1, 2009 - 7:23 AM alltracman78 OBDII is a US thing.
Other than us and maybe Canad... Apr 29, 2009 - 3:02 PM Dr_Tweak Did we do your wiring harness?
-Doc Apr 29, 2009 - 3:26 PM pitcelica Thanks for the info alltracman78. I was sure that ... Apr 30, 2009 - 8:05 AM alltracman78 Well, I stand partially corrected. I've been t... Apr 30, 2009 - 1:18 PM lagos sounds like a perfect candidate for my diagnostic ... Apr 30, 2009 - 2:56 PM lagos its in the stickies..
http://www.6gc.net/forums/in... Apr 30, 2009 - 8:45 PM speed-CCNP Will this work on a gen 4?
QUOTE (lagos @ A... Apr 30, 2009 - 8:52 PM pitcelica could you plz, post some pics of the diagnosis box... May 1, 2009 - 11:04 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 22nd, 2025 - 12:38 AM |