Would it be feaseable Options

[reko]

http://cgi.ebay.ca/JDM-95-OEM-Celica-GT4-T...p3286.m20.l1116

Would it be possible to buy this kit which includes front clip and rear clip and install the rear onto a ST204 GT-S ? Would the rear subframe and gearbox differential fit onto my current frame (if i remove the gaz tank) ? Or it would require major work to the chassis?

And what about the driveshaft?

I searched on the database but mostly found front end conversion... and the only owner of a converted to AWD here that i've found is celiman05 and he havent logged in since august 2008!

This post has been edited by reko: May 5, 2009 - 2:09 PM

[alltracman78]

If someone is going to do an AWD swap, this is the "set" to buy, that's a pretty good price and should include just about everything you need.

I can't say for sure, because I'm not too familiar with the 6th gen chassis, but depending how that rear part was cut, you could just cut out your rear floorpan and weld this in, you would then have all the mounting points and everything there for you.
Not an easy job, but no FWD to AWD conversion is.