May 6, 2009 - 11:44 PM
|
|
|
Enthusiast ![]() ![]() Joined Feb 2, '09 From new orleans La. Currently Offline Reputation: 5 (86%) |
Well I had another thread on this problem and I thought it was my spark plug wires that I just installed because the problem seemed to start right after i did the plug install. Well I thought it was the walbro fuel pump because it gets so loud and the sound keeps changing and getting higher. The problem seemed to be gone until today I floored it to get over and sure enough the hesitation and power loss & jerking began again. Then I drove it for 3-5 seconds and it stopped. So I poped the hood and looked at the engine, wires plugs sensor connections ect, and I found that if I touch my a/c idle control valve and the vacum lines that go to it the car starts to die and then kills. I am thinking when I give wot the engine moves and this is picking up the ac idle valve and the vacum lines like when I touched them with my hand and it killed the same is happening when the engine moves. Any one know about a a/c idle control valve and the vacum lines. Mine has a air sound coming out of it. Its the bolt and spring with vacum lines going to it, not sure the correct name of it
|
95st-celica check all your vac lines really good...even one va... May 7, 2009 - 12:09 AM
mk7celica The a/c is off when I do this I only use the a/c o... May 7, 2009 - 12:15 AM
95st-celica yea its normal for the engine to die a little bit.... May 7, 2009 - 12:35 AM
mk7celica Have all new vacum lines and it is doing it still.... May 11, 2009 - 11:51 PM
95st-celica are you sure your not hitting fuel cut? are you th... May 12, 2009 - 10:16 AM
mk7celica QUOTE (95st-celica @ May 12, 2009 ... May 12, 2009 - 6:06 PM![]() ![]() |
| Lo-Fi Version | Time is now: October 26th, 2025 - 3:05 PM |