Emissions w/ turbo, failed emissions... need help Options

[elvasoshexai]

Hi all,

so this is the first time i've done emissions (ontario canada) since i turboed my car and apparently i did not pass emissions.

i have a magnaflow hi-flo cat, i replaced spark plugs/wires < 1000km, fresh tank of 94 octane...

here are my results:

..................40km/h......................curb idle........
............limit....reading..result..limit..reading..result
HC ppm..66........111.....fail.....150....100....pass
CO%......0.37....0.18....pass...0.7......0.22..pass
NO ppm..0505......5.......pass............................
.............rpm.......2075..valid..rpm.....789...valid
...........dilution..13.26..valid..dilution..14.20..valid


does anybody have any ideas how to correct this? is it a simple adjustment on the emanage ultimate? is there a way to measure it to make sure you pass before i retest?

i don't want to end up, retesting, failing again, fixing something else, retesting again, fail, etc etc etc... as it will get $$$ fast

any help is greatly appreciated!!!

This post has been edited by elvasoshexai: Jul 16, 2009 - 4:41 PM

[elvasoshexai]

here are the ratios:
@ idle (cold start): high 10 - low 12
@ part throttle (cold): 13-14

@ idle (warmed up): 13-14
@ part throttle (warmed up): 14-15

but i made sure the car was warmed up before the test...

i've gotten suggestions that maybe a lower octane would help (usually run 94, maybe 91 or 89 as long as you don't boost?).. dunno if that's a good idea