Climate control wiring Options

[Cavegod]

Hi all i am curently installing cauto climate control in to a non climate control car so thats climate control out of a 1994 jdm Gen6 Celica st202 and installing it into a 1997 uk Gen6 gt st202.

does anybody know where to get a wiring diagram for the auto climate control system as i can only find one for a Gen5 st182 celica.

heres hoping

Pete

[Cavegod]

once you plug all the sensors and wiring plugs in you are left with a few wires

white/black x 2 these are earthsanywhere on the car body work

grey ignition live

yellow/red pressure sensor connect to the cars wire for the snesor.

orange- speed sensor, block connector in middle of dash behind and above the central vent, its a blue block connector on the right

green/red- battery live

blue/yellow relay earth for the fans/compressor just unclip both the cars and the CC wires discard the cc wire and push the cars wire into the block connector

blue/white heater relay same here just use the cars wire and swap it for the cc wire

thats it the rest of the wires x6 go to the thermistors

then just plug every thing else in.

hope this helps!

[BloodyStupidDave...]

Congrats on getting it all working. I started an ac to climate conversion on mine some time ago and have everything working except the actual aircon now. Must revisit it at some point and figure out the last step.

This post has been edited by BloodyStupidDavey: Aug 16, 2009 - 5:44 AM