2 Stage 3SGTE Swap thread, Stage 1.. almost done =) Options

[SlvrCelica09]

EDIT: 8/22/09
Ok guys before commenting just know my goal is 330 hp until all 2 stages is complete.. so keep that in mind when reading my setup:

95 toyota celica GT
ST205 3sgte swap
GT tranny and axles
Stage 3 clutch kit and flywheel(deciding between 2 I like)
EDIT: ST205 fuel pump
3 inch exhaust(already installed)
ST205 downpipe

Now in order to move on to stage 3 I need to figure out which engine I want.. parts for the 185(non RC) I have found to be relatively easy in case something breaks.. alot of sites have parts for the engine.. but it turns out the 185 wiring is harder than the 205.. im leaning towards the 205.. although i think finding parts for the engine is harder.. the swap should be a bit easier and at stock I would be right at my goal which is 250 hp running stock... i know for a fact there wont be an urge to raise booast levels since stage 2(AWD Conversion) of my swap would not be completed.. and this is my only car which i use for work and not for racing intentions.. 4 now.. lol

so basically I got 2 questions that have been killing me for a while now..
axles.. is it possible to mix and match GT tranny with 3sge axles.. if so that would be a delight but I highly doubt you can.. but im asking for clarification.. and 2.. what engine do you guys think I should go with.. 185 or 205?

This post has been edited by SlvrCelica09: Sep 26, 2009 - 6:32 PM

[SlvrCelica09]

ok.. monday... epic fail.. =( naw not yet lol.. we made even more progress than friday.. but there are some questions.. so jim i uploaded the pics for you.. hopefully you can make out my questions.. well heres the pics of what we have done so far




ok and now heres my questions jim.. or anyone else with 205 knowledge..

question #1.. where does these 2 hoses connect too?




question #2.. what goes in or plugs behind this part? looks like a part of the factory BOV..


question #3.. where does this plug to?


question #4.. does a cap go here? or a small hose?


question #5.. what plugs here?


question #6.. this part says "purse" on it.. so now im wondering what missing hose plugs on here..


question #7.. im thinking this is the turbo sensor.. what plugs into here? couldnt find it at all..

'
im also wondering about making new relays.. for IC pump and starter.. how exactly would you go about doing this.. ive been told.. but im a visual learner sadly.. so if anyone has pics of how to do this i would greatly appreciate..

a little summary..

perhaps i could have done even more research.. or perhaps read the manual even better.. although i suck at analizing things without pictures. I think ive done good research.. i was able to figure out alot of the wiring.. and bolted on everything that was needed.. the transmission and clutch all bolted on well.. even the wiring up to making new relays i did without much hassle.. although im sure 205 is wayyy easier than 185. Theres still much much i need to learn however... as you all can see lol.. but i dont think the answers to these questions arent something I cannot handle. Just needs comprehension and time to figure out..

This post has been edited by SlvrCelica09: Sep 28, 2009 - 9:08 PM