Feeler Project: Light Weight Pulley for 6GC, 3S for sure, and will make for 5S, 7A & 4A if feasible Options

[vincent_doggy]

Something like this:


I will def. make some for 3S, then I can test on before I proceed for other engines

One thing, I have the following stocked pulley - 3SGE, 7AFE, 4AGE
Don't have 5SFE, dunno 5S could share the same pulley with 3S? anyone know?

This post has been edited by vincent_doggy: Oct 13, 2009 - 12:47 PM

[azian_advanced]

last time i checked, i don't remember seeing anything rubber on the 5sfe crank pulley.

vince, you probably should state what sort of metal will be used or if there's any sort of additional manufacturing treatment the pulleys will undergo to resist warp against engine bay heat and high rpms. the last thing you'd want is for these to go bad on people.