UK spec OEM fog light switch/button, Installed on USDM (LHS) Pics! Options

[UTSlickVic]

(see end of Page 1 for update)

ok I'm tired of looking for info about it. But, I did find one person confirming toyota did install it on the left air vent area of the driver side. Just to ask again, Is the OEM fog light switch/button location on the left air vent area of the driver side left air vent? My car alarm light is located in that indented circle where I think the button/switch is at... I think.... if exists. Is it a button? Was it offered on US celicas? Man I dont think I am making sense... sleepy time.

ohhh dang it, if someone has I a pic that will just shut me up.

This post has been edited by UTSlickVic: Jun 27, 2006 - 7:27 PM

[ST-Autosport]

well i have been trying to connect my 8pin button too....

UK type 8pin switch to a JDM car....

1 - L = to rear fog indicator light on dash, color = R
2 - ill + = tap into any ill source on dash
3 - B = from fuse ECU-B (so +), color = G-R
4 - HR = from HEAD relay (A2 side of the relay/coil) so that fog only operates when lights are ON, color = R-Y
5 - LH = to light control switch/ daytime running light relay pin "H" (sits on top of integration relay), color = R-B
6 - FS = from front fog light relay (A2 side of the relay/coil) , so if you don't have front fogs or relay -> earth to chassis ground, color = G-B
7 - E = other side of the dash indicator light, goes to junction block Nr 3, pin 3A, color = W-B
8 - ill - = earth to chassis ground or ill - anywhere in dash

i have ALL wiring diagrams....

i tested all with a multimeter to be sure i had the correct wires....

connected it all, being sure i had everything correct....

but it did NOT work

it ended up buzzing continiusly the buzzer that my headlights were on, with ignition off...

then i connected HR pin i think to switched 12V because from schematics it came from direct 12V trough the headlight relay (hense the constant buzzer), but DO NOT DO THAT!, my swich began t smell and smoke, i quickly cut the wire...

sooo to make this short, i installed a simple button on the lower kickpanel, and used the ill pins on the fog switch as fog indicator....

expensive fog light switch lolz