Jan 2, 2010 - 6:03 PM
		 | 
		
			
			 | 
	
| 
		    
				
				
				
				
				
				
        	
        	 Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Dec 8, '03 From Lancaster CA Currently Offline Reputation: 6 (100%)  | 
       
			
			 
				Well I finally got around to building turbo pipes. that all went fairly smooth. It was tough trying to figure out the routing, i didnt want to go over the head like most FMIC setups. So i clocked the turbo down and went the way i did.  
			
			So on the dyno, I ran into the same issue that the Scion is running into with the AEM FIC. We were hitting a block at 4000 RPM,s the car would just shut off. After a quick run to Radio Shack, picked up some 1K ohm resistors and fixed the problem. ill post pics of that later if wanted. The AEM FIC is a good unit and it works well. i need to go back and finish some fine tuning. im getting a lean condition at throttle tip in. So with that said and done, i made 176HP and 230lbs TQ at 6.5psi. im on the stock exhaust after the ebay downpipe so i really need to open that up. i plan on upping the boost to about 10psi. ![]() ![]() ![]() ![]() ![]()  
				This post has been edited by Smaay: Jan 5, 2010 - 11:38 AM -------------------- 2001 Celica GT-S Turbo 
					
		1997 Supra TT 6speed 1997 Celica 3MZ/1MZ swap 1990 Celica All-Trac  | 
	
![]()  | 
	
			
			   Jan 3, 2010 - 12:23 AM
		 | 
		
			
			 | 
	
| 
		    
				
				
				
				
				
				
        	
        	 Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Dec 8, '03 From Lancaster CA Currently Offline Reputation: 6 (100%)  | 
       
			
			 
				i did, the above link where i got the pipes.
				
				
				
			 
			
			-------------------- 2001 Celica GT-S Turbo 
					
		1997 Supra TT 6speed 1997 Celica 3MZ/1MZ swap 1990 Celica All-Trac  | 
	
 Smaay   Finishes turbo system, got on a Dyno   Jan 2, 2010 - 6:03 PM
 
 95st-celica   pics not working homie   Jan 2, 2010 - 6:04 PM
 
 Smaay   should be working now   Jan 2, 2010 - 6:10 PM
 
 manphibian   no   Jan 2, 2010 - 6:21 PM
 
 Smaay   wierd i can see them. try looking here
http://www...   Jan 2, 2010 - 6:24 PM
 
 presure2   lookin good man!
thats a greddy type s BOV? st...   Jan 2, 2010 - 7:34 PM
 
 spitfiremk16   mind if i ask what the resisitor is for? i plan on...   Jan 2, 2010 - 8:04 PM
 
 Smaay   no its a micky mouse BOV. i get the pipe kits from...   Jan 2, 2010 - 9:03 PM
 
 spitfiremk16   checked out the pics and i like the piping, that k...   Jan 2, 2010 - 9:37 PM
 
 Smaay   added the dyno to first post   Jan 5, 2010 - 11:39 AM
 
 GriffGirl   That's a really clean, nice looking build...   Jan 5, 2010 - 3:37 PM
 
 Smaay   QUOTE (GriffGirl @ Jan 5, 2010 - 12...   Jan 6, 2010 - 12:42 AM
 
 jeffrosie   Looks like your water pipes for turbo cooling are ...   Jan 5, 2010 - 4:25 PM
 
 whatthe   Oh man looking sick. I want to join this 5sfte clu...   Jan 6, 2010 - 11:20 AM
 
 D_Dawg   Will you be relocating the oil filter?   Jan 6, 2010 - 10:41 PM
 
 Smaay   i dont have a plan to relocate it.   Jan 8, 2010 - 8:45 PM
 
 bmj67   did you dl your new tune from the fic   Jan 8, 2010 - 9:27 PM
 
 Smaay   not yet, i guess ican do that real quick for every...   Jan 9, 2010 - 12:27 PM
 
 Smaay   Here is my FIC MAP
Analog A is the OEM MA...   Jan 9, 2010 - 12:42 PM
 
 FunkySR   is it just me or is your fuel map a bit jumpy. I t...   Jan 9, 2010 - 5:08 PM
 
 Smaay   try pulling some timing   Jan 10, 2010 - 12:11 PM
 
 FunkySR   I read somewhere that I did not need to adjust tim...   Jan 10, 2010 - 12:29 PM
 
 Smaay   on an NA engine and you dont need to pull timing w...   Jan 11, 2010 - 9:46 AM
 
 FunkySR   ok, by the by. I will sort the timing out....but t...   Jan 11, 2010 - 1:23 PM
 
 Smaay   do it the same way i guess. read the link i posted...   Jan 11, 2010 - 3:08 PM
 
 Smaay   Talking to Jim the other day enlightened me. i gue...   Jan 14, 2010 - 11:21 AM
 
 Mstoochn   QUOTE (Smaay @ Jan 14, 2010 - 11:21 ...   Jan 14, 2010 - 1:40 PM
 
 Smaay   i was thinking about that. what head 3S-GE or 3S-G...   Jan 14, 2010 - 4:22 PM
 
 bccentaur3   Looks like he means 3sge head. Thats what I'm ...   Jan 14, 2010 - 4:37 PM
 
 Mstoochn   QUOTE (bccentaur3 @ Jan 14, 2010 - 5...   Jan 14, 2010 - 5:02 PM
 
 Smaay   well i better start doing research. does the 5S ma...   Jan 14, 2010 - 5:42 PM
 
 Mstoochn   QUOTE (Smaay @ Jan 14, 2010 - 6:42 P...   Jan 14, 2010 - 5:59 PM
 
 Smaay   well after reading through this, i think im gonna ...   Jan 15, 2010 - 9:51 AM
 
 bccentaur3   Thats a gen 1 3sge head. Thats what I'm using ...   Jan 15, 2010 - 1:30 PM
 
 Smaay   uummm yeah! im definatly not going to mess wit...   Jan 15, 2010 - 2:22 PM
 
 GriffGirl   I hate that you have every car that I really, trul...   Jan 15, 2010 - 6:12 PM
 
 Smaay   you have to get down here first   Jan 17, 2010 - 12:21 PM
 
 GriffGirl   I might be in vegas at the end of the month, don...   Jan 17, 2010 - 7:59 PM
 
 Smaay   Vegas baby! i dont know if i posted it on here...   Jan 20, 2010 - 3:24 PM![]() ![]()  | 
	
| Lo-Fi Version | Time is now: November 4th, 2025 - 10:03 AM |