 '94 ST, possible to pull axles w/o unbolting from the spindle? |
 Jan 3, 2010 - 7:57 PM
|
 
|
 Enthusiast  Joined Oct 16, '02 From Hohenwald, Tennessee Currently Offline Reputation: 1 (100%)  |
Haven't posted here in ages. But that's cause the Celica hasn't really had any major problems. That's a good thing
 Just wanted to know if anyone has ever tried to pull the driver side axle from the C52 tranny without unbolting it from the spindle? I have a busted tranny seal, and I know the pain of pulling an axle. Just hoping I can bypass all the hard stuff and get the axle out quickly to change the seal. If not, I guess it's time to get dirty 
|
 |
Replies
|
Jan 4, 2010 - 12:30 PM
|
|
 Enthusiast Joined Feb 7, '07 From Portland, Oregon Currently Offline Reputation: 67 (96%) |
I've been able to pull my axle w/out unbolting it from the spindle, for the same exact reason, bad tranny seal where the axle shaft goes in. Getting it out was fine, but getting it back in is more difficult; IIRC if you loosen the control arm, it gives you enough play to pop the axle back in.
--------------------  |
Posts in this topic
Delta_Phoenix '94 ST, possible to pull axles w/o unbolting from the spindle? Jan 3, 2010 - 7:57 PM
Euphoria it would probably be harder doing it without undoi... Jan 4, 2010 - 12:22 AM playr158 unbolt the bottom ball joint from the control arm ... Jan 4, 2010 - 1:14 PM
Hanyo i just replaced this seal 3 days ago. took about 2... Jan 4, 2010 - 6:46 PM Delta_Phoenix Thanks for all the help. Now I'm not even sure... Jan 4, 2010 - 8:46 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 25th, 2025 - 5:33 PM |