6G Celicas Forums

Welcome Guest ( Log In | Register )

> Slave cylinder install
post Jan 6, 2010 - 2:46 PM
+Quote Post
my96celica

Enthusiast
*
Joined Jul 15, '07
From High ridge MO
Currently Offline

Reputation: 0 (0%)




Can someone walk me through on how to replace my Slave cylinder? Does anything need to be taken off before hand? Should I get a little plastic tube for the valve when I bleed it?
 
Start new topic
Replies
post Jan 6, 2010 - 4:59 PM
+Quote Post
GriffGirl



Enthusiast
*****
Joined Feb 7, '07
From Portland, Oregon
Currently Offline

Reputation: 67 (96%)




It's super straight forward - and yes, the slave is attached to the block, actually, IIRC the top of the tranny? I don't remember off hand... you'll need a 9mm flared-nut wrench to unscrew the hard line that runs to the slave, and also to unscrew the bleeder screw. It's really straight forward though, IIRC you just unbolt the old one and put in the new one, bleed the line and go.

From the BGB:
QUOTE
CLUTCH RELEASE CYLINDER
Removal & Installation
Disconnect hydraulic line at clutch release cylinder. Remove
bolts and clutch release cylinder. To install, reverse removal
procedure. Bleed hydraulic system.


This post has been edited by GriffGirl: Jan 6, 2010 - 5:00 PM


--------------------

Posts in this topic
- my96celica   Slave cylinder install   Jan 6, 2010 - 2:46 PM
- - razor7   QUOTE (my96celica @ Jan 6, 2010 - 11...   Jan 6, 2010 - 4:48 PM
- - GriffGirl   It's super straight forward - and yes, the sla...   Jan 6, 2010 - 4:59 PM
- - GriffGirl   Hah! Looks like I've already taken a pic o...   Jan 6, 2010 - 5:03 PM
- - my96celica   Thanks guys!   Jan 7, 2010 - 1:08 AM
- - trdproven   look down and youll see it in front.   Jan 7, 2010 - 9:31 AM
- - my96celica   Thanks to all of you my car is running again.   Jan 8, 2010 - 4:42 PM


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: June 14th, 2025 - 3:26 AM